How to make the automobile sheet metal parts better to prevent rust?

That car is easy to keep a car difficult, especially the winter weather is more, the wet weather, the paint of automotive sheet metal cars is easier to rust, looked rusty car was distressed and angry, so, how to protect the paint paint and metal parts to prevent rust?

Toothpaste can be temporarily rustproof

And that is to use ordinary toothpaste to deal with it. When new small wounds are found, apply the toothpaste gently to the scratches. Don't forget to apply it after the rain or the car wash. This can generally reduce the mark mark, and can also simply play the role of isolation to prevent rust, in the short term there is no problem. Especially the white car paint, the effect is most obvious.

Lacquer pen can handle small scratches

If rust is not very serious, can be made of very fine water sandpaper dip gently remove rust, but not without direction or grinding, with straight grinding. After the finish is completely cleaned, a layer of primer is coated. If a new scratch, can be cleaned and painted directly on the primer. Then, if the vehicle is equipped with a canister of the original paint, you can wait for primer is dry, and then water sandpaper to smooth, put in the original factory primer paint. If there is no original paint, you can buy a paint pen and use the brush to handle the color. Although this kind of treatment didn't go to the beauty shop, the effect is good, but if it's small or not, it can prevent rust from enlarging and aggravating.

Handle small corrosion point by yourself

For the slight scratches or rusts that have occurred in the body, if the owner is prone to rust, it is not worth the cost of going to the car beauty shop. Then, the owner can handle it with some hands-on hands-on methods.

It's better not to cover the car

Vehicles parked outside, if encountered windy and rainy weather, the inner layer of car clothing will repeatedly draw paint, especially if the car is blown into sand, it will draw numerous small scratches on the body, and a long time will also cause the paint to appear black. In addition, after the wind do not directly duster or wipes clean sand on a body, but should be washed with water, and also to prevent the duster and the cloth sand scratches paint.

Do soft finish glazing

Some vehicles with more soft paint are likely to create fine scratches on the body of the body during high speed. For this type of car body, can give play to seal, it can form a mesh of solid protective film, improve the surface hardness, the effect can be maintained for about a year. And the coating can also play a similar role. Besides, chassis armor or plastic sealing can be carried out at the bottom of the vehicle, which can protect the chassis from acid rain and corrosion. The original protection layer is not easy to crack and fall off, and it can also prevent the impact of small stones on the chassis when driving.

Humidity in the area of water accumulation

During driving, it is unavoidable to encounter rain or snow or muddy and wet roads. Some sludge at the bottom of the car and the floor inside the vehicle are easy to store up sludge. If the owner doesn't clean it in time, it will hide the moisture. Therefore, the hub outer edge, doors, trunk bottom corner, the key hole and the wiper frame and other parts of the activities, to carry out regular inspection, and keep the door and body of each drainage hole unblocked, check the car covering moisture, such as carpet, floor to prevent rust.

Watch out for small wounds

The car paint surface often corroded, in addition to the common collision, scratching, driving tires up small rocks play in the finish, will enable the emergence of a peeling paint dots, a long time will have a small spot. And these small scars, because most of them are in the insignificant, are easily ignored. Therefore, regular inspection of the car body, engine hatch cover and the body around, once found to be timely to the professional beauty shop to handle.

Sources: Online cars