What is the difference between the hardware mold and the automobile stamping die?

The difference between the die and the hardware die of the automobile stamping parts and the requirements of the raw materials

Automobile stamping parts, because they are website products and key words, so in the learning requirements, it is to achieve a comprehensive and specific. Therefore, the content of the knowledge contained in it, as well as the related problems, are all involved, and one can not be omitted. Then, based on this, the following will be done immediately to improve the efficiency of the study.

What is the FLUSH in the measurement of the inspection tool for the automobile stamping parts? In addition, which parts of the car are required to have a four step stamping process?

The test of automobile stamping parts, then, the English FLUSH in the measuring instrument, its professional interpretation, is for the homogeneous plane test. In the car parts, there are four stamping processes for large covers, and they all belong to automobile stamping parts.

Is there a difference between the stamping die in the stamping part of the car and the metal stamping die?

In stamping die stamping, if the metal stamping die are compared, then, the two are different, because, for the former, which there are many requirements of A surface technology, and for the latter, it is not this requirement, therefore, will come to this conclusion. So, the difference between the two is mainly on the technical requirements.

What are the specific requirements for the automobile stamping parts on the raw materials?

The specific requirements of the automobile stamping parts on the raw materials are as follows:

The raw material of the stamping part is to have the quality proof, and it is to meet the relevant technical requirements, otherwise, it can not be used. In addition, we can do some corresponding analysis or laboratory work to check the material performance and whether there are any defects, so as to determine whether it is available. And, if necessary, the reinspection of the raw materials can be carried out to ensure no loss.